If this pump was running when the power went out, automatically start it again once the device reconnects - after the delay below, so it doesn't restart the instant power returns. Off (default) means nothing restarts on its own; you'd start it yourself from here or the panel.

Automatically starts this pump at a set time every day, and stops it at another. Off (default) means nothing runs on a schedule; you're always in direct control. If you manually stop it during the "on" window, it stays off until tomorrow's cycle - the schedule never overrides a manual stop the same day. Requires an active internet connection to execute.

Get an alert on this browser/device when this pump's motor starts or stops, or it loses power. Enabled separately per device - turning this on here doesn't affect any other device.

Receive WhatsApp alerts for power loss, motor start/stop, and reconnection. Enter your international phone number with country code without + (e.g. 919876543210).

Reboots the ESP32 - back online in about 10-20 seconds. The motor itself isn't affected either way; it keeps running or stays off exactly as it was, since that's controlled by the starter panel's own hardware, not the device.

Always installs the latest published release.

Clears WiFi, name, owner, and WhatsApp config. Device stays reachable locally - it starts broadcasting its own setup WiFi network again immediately, but goes offline from this dashboard until someone reconnects it in person.